Featured with the new topside airway to bottom side chimney intake the Cleito will take flavor and vapor production to next levels, as well as guaranteeing zero leaks. Top fill, easy to disassemble for ultra-low maintenance and convenience of everyday use. Utilizing the well-established Cleito coils, brings you storm clouds of flavor.
Capacity: 2.0ml 3.5ml (depending on which coil you have installed)
The Cleito EXO has an improved airflow system, with the air slots wide open on the top-side of the tank, the airflow travels from the top then passes the coil, bringing you massive flavor and vapor production;
Cleito EXO Atomizer
With its fully interchangeable coils with Cleito tank just adds more convenience to your daily vaping.
Cleito EXO Top-Fill Tank
Just like its predecessor, Cleito EXO is a top fill tank, simply unscrew the top cap and you can add your favorite e-juice in no time.
To avoid leakages of e-liquid into your mouth piece or into the middle tube of the tank, make sure you refill the Aspire Cleito EXO tank using a needle point bottle or refill kit or a glass dripper.
Please be aware if you don’t refill your Aspire Cleito EXO tank properly (Top fill), you might draw some eliquids to your mouth every time you vape, or your vaping experience might be disturbed by a gurgling sound caused by the excess of eliquid inside the middle tube of the tank.
Sub-ohm tanks and coils have a resistance which is under 1.0ohm. Sub ohm atomisers/coils tend to be bigger, as a result, it can utilise more power, eliquid and cover a greater area of wick. This combination results in massive vapour production.
High-powered device paired is required for sub-ohm vaping (a separate high-drain battery may be required - e.g. the Efest 18650 battery or rillipower 26650).
"Direct-to-lung" is the suggested vaping style for sub ohm devices (as opposed to "mouth-to-lung" - i.e. how a traditional cigarette would be smoked).
When using sub-ohms tank like the Aspire Cleito Exo tank, its highly recommended to use eliquids which VG is higher than 80% and if using nicotine eliquids, it must be under 6mg, otherwise you will feel it peppery/harsh on your throat when vaping.
Priming: Whenever you install a new coil you will want to make sure you prime it before using it. Priming a coil will ensure that the wick is fully saturated with e-juice prior to its first use. This would substantially lower down the risk of burning the wick or damaging the coil. Check instruction before use.
Steps to prime your coils: Add 4-5 drops of e-liquid directly into the coil head, close the airflow switch, then refill the tank as per instructions. Prior to attaching the tank to the battery/MOD lightly blow air through the mouthpiece about 5 times. Make sure the airflow switch located at the bottom of the tank is closed before refilling it with e-liquid. If the airflow switch is left open, the tank will leak eliquid while priming the coils.
Open the airflow soon after priming, place the tank up right and wait 3 – 5 minutes before you start vaping.