Small but powerful the Innokin Kroma MOD does range up to 75watts wattage and optional Temperature control.
Innokin Kroma mod is an easy to operate MOD matched with inset, discreet childproof tank “Innokin Slipstream tank” pre-boosted to enhance the e juice flavour from each vape, and internal 2000 mAh battery inbuilt to perform a full day vaping. An ultra-fast, USB charging facility, and the ability to carry on vaping while the battery charges, ensures round-the-clock vaping with your Kroma kit. This mod has been optimized for simple vaping – even in temperature control mode. If you’ve not tried vaping with temperature control (TC) atomizer coils, the iTaste Kroma TC starter kit offers an easy route into this advanced vaping option. When you vape in TC mode with special Nickel, Titanium or Stainless Steel atomizer coils, you can set the coil temperature for an incredibly consistent vaping experience. If you prefer to stick with regular variable wattage (VW) vaping, check out the Kroma mod’s ‘pre-boost’ feature for maximum e juice flavour. A neat display screen on the side of the mod keeps you updated with your chosen settings.
You must prime the Slipstream tank/coil prior to using it the first time: start vaping at low wattage (7watts). Take 5 puff before you start incrementing the wattage progressively by 1 watt, to the minimum recommended resistance as stated on each coil head.
ABOUT SUB-OHMS TANKS
Sub-ohms tanks use coils which resistance is under 1ohm
Innokin Kroma 75W MOD is designed for sub-ohm vaping when using under 1.0 Ohm resistances coils. It requires more vaping experience to use safely, and extra care should be taken when using a sub ohm tank.
Be aware to only use e-liquid with less than 6mg of nicotine for sub-ohming, and PG/VG ratio containing at least 70% VG, as your vapour may taste harsh otherwise. Sub ohm vaping produces a bigger throat hit than standard coils, and extra care should be taken.
ABOUT RECHARGING THE BATTERY
Do not charge Innokin Kroma 75W MOD with chargers different from the ones supplied with your kit and an Electrical safety approved wall charger “Soulblu Wall Charger”. Alternatively you can use Soulblu Car charger connected to provided chargers with the kit.
Clean (dry) the threaded fitting of your MOD every time you recharge your batteries, to avoid shortage.
MAINTENANCE AND CARE
Make sure the Innokin Slipstream tank system doesn’t leak eliquid into the fitting of the MOD - Follow instruction on how to use the tank or clearomiser properly to avoid leakage -.
Change the coil head periodically when vaping start tasting burnt or the amount of vapour produced start declining significantly or the LED screen displays “check atomiser”
KEEPING BATTERIES SAFE
Do not carry or store them loose or near metallic objects.
Always keep your batteries dry and away from water.
Never expose your batteries to an open flame.
Visually inspect your batteries regularly. If the wrapper is damaged in any way DO NOT USE IT. It is important to either replace the battery or take the battery to a shop to have it re-wrapped or replaced.
Do not overcharge or over discharge your batteries. If a battery has been over charged/discharged DO NOT USE IT and properly discard it.
Do not charge your batteries unattended or while sleeping.
Check on charging batteries periodically (recommended every 30 min) and promptly remove them from the charger as soon as they finished charging.
Do not expose your battery extreme temperatures both heat and cold.