The Innokin Scion 2 tan features a Delrin Drip Tip which can be swapped out for an Innokin wide bore acrylic drip tip or even the drip tip you’re currently using. This is to help you customize your tank to match your style (the SCION II fits drip tips from some of the most popular 24mm tanks and RDAs on the market).
The Scion 2 adopts 0.15 ohm and 0.36 ohm BVC coils, focusing on optimal flavor and massive clouds. The Acrylic wide bore drip tip prevents your lips from burring. The Innokin Scion 2 would be a good choice for flavor and cloud chasers.
To avoid eliquid leakage please ensure you refill the Innokin Scion 2 tank using a dripper or needle point bottle. Follow manufacturer instructions.
Overfilling or not refilling the Innokin Scion 2 tank properly (Top fill), you might draw some eliquids to your mouth every time you vape, or your vaping experience might be disturbed by a gurgling sound caused by the excess of eliquid inside the middle tube of the tank.
Sub-ohm tanks and coils have a resistance which is under 1.0ohm. Sub ohm atomisers/coils tend to be bigger, as a result, it can utilise more power, eliquid and cover a greater area of wick. This combination results in massive vapour production.
High-powered device paired is required for sub-ohm vaping (a separate high-drain battery may be required - e.g. the Efest 18650 battery or brillipower 26650).
"Direct-to-lung" is the suggested vaping style for sub ohm devices (as opposed to "mouth-to-lung" - i.e. how a traditional cigarette would be smoked).
When using sub-ohms tank like the Innokin Scion 2, its highly recommended to use eliquids with PG/VG ratio 20/80, and if using nicotine juices, it must be under 6mg, otherwise you will feel it peppery/harsh on your throat when vaping.
You must Prime your coils: Whenever you install a new Plexus/Scion 2 coils you must prime it before using it. Priming a coil will ensure that the wick is fully saturated with e-juice prior to its first use. This would substantially lower down the risk of burning the wick or damaging the coil. Check instruction before use.
Steps to prime Scion 2/Plexus coils: Add 4-5 drops of e-liquid directly into the Innokin Scion 2 coil head, close the airflow switch, then refill the tank as per instructions. Prior to attaching the tank to the battery/MOD lightly inhale through the mouthpiece about 5-6 times. Make sure the airflow switch located at the bottom of the tank is closed before refilling it with e-liquid. If the airflow switch is left open, the tank might leak eliquid while priming the coils.
Wait 5 minutes before vaping, switch the wattage to the lowest and draw couple of times, then progressively increase the wattage to the Wattage range recommended by the manufacturer.