Vaping without priming your coils or running your Personal Vaporiser (Ecigarette) at a wattage or voltage higher than the one recommended by the manufacturer might damage your coils or reduce its life. As a result, you might get a dry hit or burn taste when vaping. If that happens you will be required to change the coil head and prime it so you can enjoy a smoother vaping experience.
Priming:Whenever you install a new Innokin Zenith coil you will want to make sure you prime it before using it. Priming a coil will ensure that the wick is fully saturated with e-juice prior to its first use. This would substantially lower down the risk of burning the wick or damaging the coil. Check instruction before use.
- Instruction on priming Innokin Zenith coils: Add 4-5 drops of e-liquid directly into the coil head, close the airflow switch, then refill the tank as per manufacturer’s instructions. Prior to attaching the tank to the battery/MOD lightly suck air through the mouthpiece about 5 times.
Make sure the airflow switch located at the bottom of the tank is closed before refilling it with e-liquid. If the airflow switch is left open, the tank might leak eliquid while priming the coils.
Wait 5 minutes before vaping, switch the wattage to the lowest and draw couple of times, then progressively increase the wattage to the range recommended by the manufacturer.