Whichever tank you choose to match the Eleaf istick 20W Mod, you must prime the tank/coil prior to using it the first time: start vaping at low wattage (7watts). Take 5-10 puff before you increment the wattage progressively by 1 watt, to the minimum recommended resistance as stated on each coil head.
ABOUT SUB-OHMS TANKS
Sub-ohms tanks use coils which resistance is under 1.0 ohm
Eleaf istick 20W Mod is NOT designed for sub-ohm vaping, make sure you use tanks which coils are higher than 1.3 Ohm.
ABOUT RECHARGING THE BATTERY
Do not charge Eleaf istick 20W Mod Mod with chargers different from the ones supplied with your kit and an Electrical safety approved wall charger “Soulblu Wall Charger”. Alternatively, you can use Soulblu Car charger connected to provided chargers with the kit.
Clean (dry) the threaded fitting of your MOD every time you recharge your batteries, to avoid shortage.
MAINTENANCE AND CARE
Make sure your Tank system, or clearomiser doesn’t leak eliquid into the fitting of the MOD. Follow instruction on how to use the tank or clearomiser properly to avoid leakage.
Change the coil head periodically when vaping start tasting burn or the amount of vapour produced start declining significantly or the LED screen shows “check atomiser”
KEEPING BATTERIES SAFE
Do not carry or store them loose or near metallic objects.
Always keep your batteries dry and away from water.
Never expose your batteries to an open flame.
Do not overcharge or over discharge your batteries. If a battery has been over charged/discharged DO NOT USE IT and properly discard it.
Do not charge your batteries unattended or while sleeping.
Check on charging batteries periodically (recommended every 30 min) and promptly remove them from the charger as soon as they finished charging.
Do not expose your battery extreme temperatures both heat and cold.