- THE FIRST OF ITS KIND ISOLATION STRUCTURE DESIGN:
Innovative Isolation Structure Design separates coil and juice chamber, allows consistent, intense flavor at every puff. Also, reduces dry hit potential to extend the tank life cycle. A fresh vape for every vape.
- BALANCED TRIANGULAR ADJUSTABLE AIR FLOW
Perfectly balanced triangular air flow provides users the smoothest vape. Even at 200W, users able to experience warm but not burn and intense flavor vape.
- EUC STYLE COIL REPLACEMENT SYSTEM
Plug-n-Pull coil change method for a fast, easy, mass free replacement process
- FULL RANGE OF COILS AVAILABLE (25W-200W)
GT Cores are specially designed to fit into the NRG tank series, and now it is available for the all new Cascade Sub-Ohm Tank! It comes in traditional cotton and signature CCELL Ceramic in different resistances, from GT 2 all the way up to GT 8. Gear Up with GT Cores as you desire!
- SLIDE-N-FILL DESIGN The Slide-n-Fill design makes refill easier than ever
To avoid eliquid leakage please ensure you refill the Cascade 7ml tank using a dripper or needle point bottle. Follow manufacturer instructions.
Overfilling or not refilling the Cascade tank properly (Top fill), you might draw some eliquids to your mouth every time you vape, or your vaping experience might be disturbed by a gurgling sound caused by the excess of eliquid inside the middle tube of the tank.
Sub-ohm tanks and coils have a resistance which is under 1.0ohm. Sub ohm atomisers/coils tend to be bigger, as a result, it can utilize more power, eliquid and cover a greater area of wick. This combination results in massive vapour production.
High-powered device paired is required for sub-ohm vaping (a separate high-drain battery may be required - e.g. the Efest 18650 battery or brillipower 26650).
"Direct-to-lung" is the suggested vaping style for sub ohm devices (as opposed to "mouth-to-lung" - i.e. how a traditional cigarette would be smoked).
When using sub-ohms tank like Cascade, its highly recommended to use eliquids with PG/VG ratio 20/80, and if using nicotine juices, it must be under 6mg, otherwise you will feel it peppery/harsh on your throat when vaping.
You must Prime your coils: Whenever you install a new Vaporesso GT coil you must prime it before using it. Priming a coil will ensure that the wick is fully saturated with e-juice prior to its first use. This would substantially lower down the risk of burning the wick or damaging the coil. Check instruction before use.
Steps to prime Vaporesso GT coils: Add 4-5 drops of e-liquid directly into the cotton area of the coil head, close the airflow switch, then refill the tank as per instructions. Prior to attaching the tank to the battery/MOD lightly inhale through the mouthpiece about 5-6 times. Make sure the airflow switch located at the bottom of the tank is closed before refilling it with e-liquid. If the airflow switch is left open, the tank might leak eliquid while priming the coils.
Wait 5 minutes before vaping, switch the wattage to the lowest and draw couple of times, then progressively increase the wattage to the Wattage range recommended by the manufacturer.